Hello Everyone. I am trying to install a small run of neopixels. I have installed circutpython, blinka, neopixels on a venv. I'm on a pi 3 A+. Using bookworm. I have a wavescreen touchscreen hat installed along with a 3ch relay. Pin 12 or .d18 should be available for use. Along with some other .d* pins.
I have seperate power for the leds and have a bidirectional leveler installed to boost the signal.
When I try to run a simple code to turn on and change the color red I get the same results. The code doesn't run. I get an error saying :
ws_2811 error code -3 revision not supported
I have tried updating all the requirements and updating the rpi ws_281* file. I can't figure out what's wrong? Unless there is an issue with the screen or other overlays I'm missing.
I have seperate power for the leds and have a bidirectional leveler installed to boost the signal.
When I try to run a simple code to turn on and change the color red I get the same results. The code doesn't run. I get an error saying :
ws_2811 error code -3 revision not supported
I have tried updating all the requirements and updating the rpi ws_281* file. I can't figure out what's wrong? Unless there is an issue with the screen or other overlays I'm missing.
Statistics: Posted by Jayb713363 — Sun Dec 22, 2024 9:21 am